You have inspired me. I wanna be a forklift tech. Just like you
@jeremysturgill8426
2 жыл бұрын
First step: leave your current place of employment 😂
@kevinmoore7635
2 жыл бұрын
@@jeremysturgill8426 ha I did that back in January.
@c.n.9074
Жыл бұрын
Shouldn't be a problem... for tools you will need a big hammer, a bigger chisel, some paper towels for cleaning and some rubber gloves.
@pwilliams2537
2 жыл бұрын
I have a question what type of hydraulic oil do you use to full the reservoir
@billbrady6514
2 жыл бұрын
Do you have any short cuts like this to replace the column rollers without taking off the entire mast? I have a crown tc-3020-30. Same setup your using in this video
@jeremysturgill8426
2 жыл бұрын
Hey sorry for the delay. Yt is not notifying me of messages on my videos. If you are referring to the mast rollers, there is no way to replace them without mast disassembly.
@billbrady6514
2 жыл бұрын
I have a question for you. What would you recommend I use to clean and degrease the chains? I’ve used a few chemicals from dobmeir but nothing seems to clean them enough so I can re-lube them.
@jeremysturgill8426
2 жыл бұрын
Brake clean will clean off most all the old grease and gunk from the chains.
@Roosters-rants1977
3 ай бұрын
Those cylinders are a bitch to get all the way out. I just remove the ram
Пікірлер: 10