Detailed instructions for the installation of the cruise control in the #Audi #A6C6 2008.
The cost of the kit is less than $10
Steps:
1) Removing the airbag Torx T30
2) Steering wheel Spline M12
3) Bottom cover Torx T8, T25
4) Ring 5 latches
5) CC Connection Torx T8
6) Bottom panel, head 8
7) Unplug connector under the steering wheel
8) Unplug the "white" connector
9) Connecting the new cable Male-Female
10) Cutting a new hole in the steering wheel housing
11) the problem with the transmission
12) Coding and activation of cruise control via VAG-COM
13) Test race
14) Conclusion
Original cruise control kit VAG 8E0054690
Lower steering column cover WITH the CUTOUT VAG 4F0953512E6PS
Non-original CC Topran 110110755, PATRON P15-0024, OSSCA 01902
Long screws 2pcs VAG N90906802
Male connector BMW 12527512135
Female Connector VAG N90764701
Cable
Coding VAG-COM to connect the cruise control
1) Delete all issues
2) Go to 01-Engine
If you can click "Coding II -11" click and instead of 00000 enter the code 11463 and the save
Else Coding - 07 - «Long coding», select #6 bytes (default 00) and put the very first tick "Bit 0" Cruise Control Installed then the top button "Exit" - «Do It!», "Coding accepted" window should appear»
3) Go to the controller 6 - Steering Wheel - Coding - 07 - change the penultimate digit to 4. (was 0002011 became 0002041) - «Do It!»
This coding is completed to check the operation of the CC need to go on the road and gain speed of at least 30 km/h
Possible problem:
Error 049409 in block 01 - Engine
049409 - No communication with transmission control module U0101-009
Error 01315 in block 03 - ABS Brakes
01315 - Transmission Control Module 004 - No signal / Communication
Solution - poorly connected white connector, you need to make sure that the upper part near the body is connected (the connector consists of two parts)
Негізгі бет Автокөліктер мен көлік құралдары Cruise control installation manual Audi A6 C6 (articles, coding VAG-COM)
Пікірлер: 195