I GREATLY appreciate this! Could not for the life of me figure out what I was missing (second set of screws, of course. Worse part was I even looked in the holes and thought nothing of the sockets in them).
@matthewmannminarik8386
5 жыл бұрын
This helped a lot! Mine came out exactly as yours did. I wouldn't have known about the second set of allen screws without you telling me. Again. Thank you.
@robertheinkel6225
6 жыл бұрын
There is a tool that comes with the new clutch disk, that gives you the exact measurement for each of the springs. It rests on the springs, and you adjust each spring until the measurement is exact. Then tighten the jam nuts to hold it. Recheck the measurement once the bolts have been locked in place. You will need a very thin 7/16 wrench to hold the bottom bolt. I repaired many if these when I worked for IH. The engine does not have to be removed to remove the clutch. When done, adjust the mower engagement rod, so it just makes contact with the center button when engaged.
@megatron7057
3 жыл бұрын
Can you help me with this very issue. Shops around me tell me they dont have the speciality tool to fix my clutch plate lol. 2 of the busiest shops in town, duno how to fix my 127...
@shobud7561
2 жыл бұрын
@@megatron7057 if you don't have the tool / guage you can't adjust the clutch properly.
@megatron7057
2 жыл бұрын
@@shobud7561 fair but would your shop hold your mower for 2 months and than charge ya 80 bucks to look at it? Was a crock tbh
@joselepepe2
14 күн бұрын
This is useful -- but how do you lone up the holes with the slots -- I cannot turn the mechanism to do so
@shelleyhicks2541
4 жыл бұрын
Very helpful video! Way to GO!
@megatron7057
3 жыл бұрын
Anyone know of a place to get a used or rebuilt pto for these kohlers. Got a 127 the shops in town duno how to fix. Said its a broken clutch plate and they need a speciality tool and dont have the part.
@harryfp1494
2 жыл бұрын
Midwest super cub might know give them a call
@Jacobsen-ij9hn
5 жыл бұрын
Mine only has 3 set scres
@IPullingTractor
11 жыл бұрын
There's no need to use a block of wood to rotate the clutch hub. Just grab the hub with your hand and tap the center button at the same time to momentarily rotate the hub. And how's it going to spark when there's no power going to the ignition???
@cheekybastard99
4 жыл бұрын
huh
@shobud7561
2 жыл бұрын
You don't have a clue as to what your doing. You never mentioned the anti rattle springs were missing as you removed the clutch . Hopefully you will replace them " if not the clutch disk will rattle and could break off the fingers of the PTO Disk .
Пікірлер: 16