I got the OEM hr meter at a local Cub dealer . It was $50 . Worth having . I have the ZT1-50. Kowasaki engine. Love the mower .
@SteeveeDan
2 жыл бұрын
I definitely want one so I'll be getting that add-on in gear real soon!
@larrycroft470
2 жыл бұрын
Just found your channel Brother. i subbed and turned the bell on. I have a friend who has a 46 inch Cub Cadet ZT1. He has owned 2 other Cub Cadet zeron turns in the past. They lasted about 14 years each. I am sharing your comments with him. Looking forward to more uploads.
@SteeveeDan
2 жыл бұрын
TY so much! My plan this spring is to fully service the machine and add an hour meter. There will be more videos about the cub!
@edrimeikis9270
3 жыл бұрын
Great review. I have the 46 inch and feel the same way about cub cadet in general. The throttle on mine is slotted through the metal so it doesn’t have the plastic piece to pop out.
@SteeveeDan
3 жыл бұрын
Thanks for the comment!
@whit10mm72
Ай бұрын
If it comes off the rim again the slim will work great but. Take it off with a 3/4 wrench. clean the rim edges first. get it back on the rim and inflate. Then take out valve stem and put in slim. reinsert stem and fill with air. BEFORE replacing tire. roll it around and on its side to get slim around edges.
@SteeveeDan
Ай бұрын
Great advice, thanks!
@beezertwelvewashingbeard8703
2 жыл бұрын
I have one like that but it's a 50" welded deck with the 23hp Kawasaki. Mine does have the hour meter which is nice and it reads out battery voltage and service reminders.
@SteeveeDan
2 жыл бұрын
I wish mine came with that!
@AaronRankin
2 жыл бұрын
Best review I've seen. Thanks
@SteeveeDan
2 жыл бұрын
TY!
@Jaybird-oo3ih
Жыл бұрын
I have the Ultima ZT 1 54” with the Kohler 24 hp engine. Mine came without the hour meter, I called the CC parts number fully intending to purchase the meter. The lady was really nice, looked up my model and serial numbers and advised me my unit was supposed to have the meter and placed a no charge order and sending it for free.
@SteeveeDan
Жыл бұрын
I should have called, maybe they would have sent me one too!
@Jaybird-oo3ih
Жыл бұрын
@@SteeveeDan I was put on hold several times but it was well worth the call. It’s my thoughts that maybe they’ve had a shortage of parts at the factory and instead of waiting for the parts needed they’re just putting them out there to meet the market demand instead? (Just my thoughts about it)
@SteeveeDan
Жыл бұрын
@@Jaybird-oo3ih That's a good point about the shortages. Thanks for sharing!
@caseynewell4922
2 жыл бұрын
If you read the tire they say not to go over 10 psi on the back mine were at 27 when I got mine
@1jw298
Ай бұрын
I’m a bit late on this one but have you had any issues with scalping the lawn while making turns??
@SteeveeDan
Ай бұрын
On flat ground, no scalping at all. I cut at 3" so maybe that's why? On hilly ground, there is a bit but very slight.
@mikebell5315
2 жыл бұрын
You're missing one of your seat adjustment bolts. There should be two adjustment bolts. One on each side.
@SteeveeDan
2 жыл бұрын
TY, never noticed that!
@vadergtcs6893
2 жыл бұрын
Is it normal for there to be black smoke on startup when the choke is applied? Runs like a champ with no smoke when once I take it out of choke position.
@SteeveeDan
2 жыл бұрын
Yes, when the choke is on it's dumps a lot of extra fuel into the engine and it can't burn it all so the result is black smoke. As long as it goes away when the choke is off, all is good!
@lovetofly32
2 жыл бұрын
I dont like that it doesn't have arm rests! I always rest my elbows on the rests to keep it steady on bumps.. thats really dumb they left those off.
@SteeveeDan
2 жыл бұрын
They would be nice to have!
@mikemcelwain
3 жыл бұрын
Zt1 54 inch 7700 choke problem, I adjusted throttle cable and now it started but now throttle only goes 3/4 of the way and choking itself out?
@SteeveeDan
3 жыл бұрын
I'd have to look at mine but sounds like you may have adjusted the cable too short.
@kid-bh1jj
4 ай бұрын
Mine sputters I changed the spark plugs fuel pump fuel filter. I does it when the blades are engaged. I have no clue what else would be wrong???
@cr250FoLife
2 жыл бұрын
Where in PA are you from?
@SteeveeDan
2 жыл бұрын
Was in N E Pa, moved to upstate NY recently though.
@len2524
Жыл бұрын
So how hard is it to pull the deck out?
@SteeveeDan
Жыл бұрын
Well, about the deck, I won't lie. If you're lucky enough to have everything lined up just right, it's not too bad. If things are off a bit, it'll make you say bad words.
@martymartin7146
Жыл бұрын
How is it on slopes and hills?
@SteeveeDan
Жыл бұрын
So far it does well. As long as the tire pressures are correct, I've had no problems with hills and slopes while mowing.
@warriorsf911
2 жыл бұрын
Any experience with it on hills?
@SteeveeDan
2 жыл бұрын
I've used it on some hills, I have a smaller hill on the new property, probably 12 to 16 degrees. At the old house there was a hill much steeper and as long as the grass was dry, I had no problems mowing up and down the hills and power hasn't been an issue at all. I didn't / wouldn't try mowing them sideways though.
@thedungeon1288
2 жыл бұрын
What! My ZT1 has an hour meters.
@SteeveeDan
2 жыл бұрын
I can't even believe mine didn't!
@thedungeon1288
2 жыл бұрын
@@SteeveeDan so I got mine at a cub cadet dealer and it is the one with a 50 in deck and kiawasaki engine. I was wondering maybe if you got it at Home Depot or tractor supply. Perhaps they do not have the hour meter. Or perhaps it is just bad quality control. I recently gave a 2 year review on my channel. Feel free to check it out.
@SteeveeDan
2 жыл бұрын
@@thedungeon1288 I did actually get it at TS. Going to be installing one soon. I'll check out your vid asap!
@beezertwelvewashingbeard8703
2 жыл бұрын
@@thedungeon1288 I bought one exactly like yours at HD in 2021, and it was the only one out of the 4 ZT1 50" mowers they had in stock with an hour meter. All 4 were the same price. Possibly an effect of the chip shortage? I'm hearing about new cars that have heated seats factory installed and other optional equipment that don't work, and supposedly they'll finish the install for you if and when they get the parts.
@sheldonhibler4033
3 жыл бұрын
Did u figured out wats wrong with ur truck
@SteeveeDan
3 жыл бұрын
Looks like a bad ABS module. Still figuring out which route I want to take, let the dealer handle it or buy an expensive scan tool so I initialize the new module myself.
@krsone1585
5 ай бұрын
FIX A FLAT WILL VOID YOUR TIRE WARRANTY.
@danielpadgett2831
Жыл бұрын
I would have just put atube in the tire
@SteeveeDan
Жыл бұрын
Fix-a-flat is the magic bullet. Even if you get another puncture, a tube would leak but the fix-a-flat will seal new punctures. I tried Green Slime with zero luck but the FAF works every time for me so far.
@danielpadgett2831
Жыл бұрын
@@SteeveeDan I've also heard fix a flat will ruin a rim too
@SteeveeDan
Жыл бұрын
@@danielpadgett2831 That's an old wives tale. FAF will harden into a foam like sealer but can be removed from a rim if so desired.
Пікірлер: 49