barehanding test leads in an open output lug compartment,under load at 480v, with no arc flash protection..and wearing flip-flops.Wonderful.
@JuanAntonioBullo-of2cx
4 ай бұрын
Muy buena observación 😅
@premnarayanpandey337
4 жыл бұрын
Good work load trail
@Phimthieunhivn
2 жыл бұрын
Ok
@ianhosier4042
3 жыл бұрын
Where is the huge fuel tank needed for that Genny? If you shorted the output could you stall that out? I did that once using an electric kettle on a Genny!
@ashissarker3615
3 жыл бұрын
Voltage up drown kno kora
@timskiff9422
3 жыл бұрын
Load bank looks small
@ianhosier4042
3 жыл бұрын
You are forgetting the purpose of the magic smoke, they just cut the video before that happened
@ianpearce5745
3 жыл бұрын
When I first started building generator"s back in the early 80's we used a saline tank and lowered 4 plates down into to solution to load test up to 500kva
@tatcheungli1040
3 жыл бұрын
1800 rpm? ☣
@frazzledude
3 жыл бұрын
It sounds more like 1500 RPM. This is probably outside North America for a 50 hertz system.
@egvettoor
3 жыл бұрын
Yes it is possible
@ianpearce5745
3 жыл бұрын
@@frazzledude most gen sets are set to run at 1500 I fitted up may different types of engines from a single cylinder lister to Cummins a Dormans using markon Leroy somer and newage alternators .
Пікірлер: 15