I just replaced one of these gear covers. It was warped and leaking at the bottom corner by the water pump,,where they usually are prone to go. I always get nervous after making a big repair like this when it's time to start it up...praying for all to go well after that much time invested😅😅
@jeffreyweston900
9 ай бұрын
This job can get so expensive until it's actually worth getting an inframe even if the motor is really not due for one! I have the same problem but not as bad..
@michaelwright1602
Жыл бұрын
Get rid of that scissor gear if you still have the motor apart. They eventually start to loosen in time, I bought mine in time. And do not forget the Lock Tite, I think it is the 409 or 904 formula for the cam gears. It is listed in the reassembly instruction in Cummins Quickserve.
@dixiemae5042
Жыл бұрын
Thanks 👊🏻💪🏻
@callistalael4113
Жыл бұрын
sending love and support #Loida
@TexasBroskiActual
5 ай бұрын
Mine only leaks there from a cold start.
@mandingo1125
Жыл бұрын
This job is a real pain in the ass. Gears are tight
@brandonbrinegar5316
11 ай бұрын
It's a pain in the ass to get that cam idler gear right at .006" before that locktite sets on the cam gear. A race against time
@ChrisTheMobileMechanic
Жыл бұрын
I'll wish it was 2500, I got quoted 19,000 for a "front structure reseal"
@StickNclutch
11 ай бұрын
Nooooo way!!! Haggai in GA would do it for less than 8 and in duncan ave new jersey 3500
Пікірлер: 11