Thanks buddy about to put new heads on my 1999 Volvo really glad you had this video
@rogeraguilar4959
9 ай бұрын
Exelent video master thank you for you time and you exelent job and experience
@terrellscaife2411
9 ай бұрын
Nice work
@naomistruckparts
9 ай бұрын
Thank you
@redtoprich
8 ай бұрын
Thx buddy!
@naomistruckparts
8 ай бұрын
No problem!
@georgerenton965
6 ай бұрын
WHAT ? I have built possibly a hundred Cummins engines in the 70’s. Never have I seen anyone use gasket cement on a head gasket. If you have problems your trying to hide, then your still going to have them. Did you check for dropped liners, or cracked head bolt holes in the block ? Where do you think all that grey primer paint they fogged the valve springs with is going to end up. Sorry for being so critical but this is out there.
@naomistruckparts
6 ай бұрын
The block was in pretty bad shape That's what the owner wanted me to do He didn't want to pull out the block to rebuilt it
@naomistruckparts
6 ай бұрын
Off course there was no warranty on it either
@garyharrington5300
10 ай бұрын
That permatex won't seal them sunk liners😂
@StevenJohnson-7991
29 күн бұрын
Permatex aviation paste is to mitigate fretting on top of the block, it doesnt fix sunk liners or warped heads
@redtoprich
2 ай бұрын
How did this engine hold up?
@naomistruckparts
2 ай бұрын
Is still running till this day
@royandrade2929
Жыл бұрын
Did the cut it, since it's old
@naomistruckparts
Жыл бұрын
No he didn't
@royandrade2929
Жыл бұрын
You shouldn't of touched it them. It could fail and come back to you, prepare to marry that engine.
@naomistruckparts
Жыл бұрын
@Roy Andrade I know what are you saying And he needed to cut the block but he didn't wanted to do it so I told the customer I'm not gonna give him any warranty so he was ok with it
@royandrade2929
Жыл бұрын
Oh ok if you told him that covers you.
@daleabed2145
Жыл бұрын
Hey buddy,you are the first guy that i seen torque the heads right,i did mine the same way and it came out to be 325-330 ft lbs torque and everyone else i talk to tells me its wrong and the torque it the old way which is much lower.i did the 90 degree,marked it and used the torque wrench to double check and it was about 325-330 so i fid them all that way.the main bearing caps also have an updated torque setting that most dont do.great job!
@naomistruckparts
Жыл бұрын
Thank you sir
@shivermetimbers8344
Жыл бұрын
If the manufacturer says to torque at a set lbft then you do so…
@diesellifechicago2329
Жыл бұрын
Where are you located ?
@naomistruckparts
Жыл бұрын
@@diesellifechicago2329 Commerce GA
@vladimirp9252
10 ай бұрын
Oil comes from under the first head under load and temperature after 190F. Two weeks ago I changed the gasket and put new bolts, but the problem did not go away. What can happen? Thank You!
Пікірлер: 25