This is so dumb. Thank you for making this video, I couldn't for the life of me figure out how to make it work. I finally just went ahead and learned how to use Orca slicer since their cutting tool is not only native but also much more intuitive and versatile.
@TheHobbyKid1
8 ай бұрын
THIS IS SO HELPFUL
@Technivorous
7 ай бұрын
Comments like this are why I do KZitem! Thank you!
@Tyguy266
10 ай бұрын
Hey buddy. It's been a min lol. I needed to know how to do this forever lol. My printer is down atm but hope I can get it back running
@onecarwood
10 ай бұрын
Don’t all other slicer have this natively?
@dwayneking773
12 күн бұрын
can you save each split piece for future printing ?
@markkyprianou4126
4 ай бұрын
Is there a way to remove the part below the plate? I want to rotate the split part after splitting.
@MisterGarp
3 ай бұрын
THIS!
@mamatuja
10 ай бұрын
I don't think it's mirroring, but it's taking the bottom part and turning it over 180°.🤔😉
@zk_6312
7 ай бұрын
I like it. Normally I use openscad and cut out a 0.1mm cube where I want to cut and use the mesh split model. This could be useful though. Now, if it could add connection points like a hole and cylinder so you can snap it together that would be even more useful.
@Technivorous
7 ай бұрын
That's a great idea!
@3DPrintsNW
7 ай бұрын
You can in meshmixer, ie hole/cylinder to snap together.
@zk_6312
7 ай бұрын
@@3DPrintsNW sounds great except I don't know how to use meshmixer. The one time I tried it confused me. I will have to try again and see if youtube has some tutorials on it.
@D0cez
6 ай бұрын
how your CURA ignores half of model while this model is not inside the borders. I can't slice my model CURA says about borders and can't slice it. Help pls
@zk_6312
4 ай бұрын
This is not really a cutting tool. It is a duplicating tool. If you could save the cut pieces I would like it a lot better, but you can't.
@3sotErik
10 ай бұрын
Sorry but I don't know of a single time I would have used this, especially if I can't rotate the parts and maintain the split.
@eugene4154
9 ай бұрын
Howdy fella, I am brandnew to this hobby , ender 3 v3se delivered today still to open box and setup Q, when you download from thingyverse or cults3d they say model can be printed in any scale I.e 1:24 or 1:32 where do I set the scale after downloading the stl file Your assistance will be great fully appreciated (it's a slot car body)
@kryptonson
8 ай бұрын
I typed in split and nothing comes up. Did they take it out?
@SackyX
10 ай бұрын
How can you split perfectly in half? Thanks in advance.
@ein_inkompetenzyt
7 ай бұрын
You could try taking your z-measurement and moving the object down half of that measurement. If my logic is sound that should work
@IAmTheCraftsman
9 ай бұрын
How do you get the custom graphics for the build table in Cura?
Пікірлер: 21