This video was recorded early in 2023. Check my newest awesome snowblower project here! - • Snowcat V1 - First vid...
Both the truck and the blower are Powered by Zeee 2S 5200mah LiPo batteries (link below, referral program). The blower gets between 20-25 minutes, and the truck gets anywhere from 45-85 minutes.
zeeebattery.co...
This is a 3D printed model snowblower from plans by Spyker workshops, who designs and sells amazing kits for personal snow removal. The blower was printed and built by me, assembly took a little over 2 months, including finding a solid way to mount it.
There is about 5 inches of powder in the first video, this second part has between 3-4 inches and the snowblower works flawlessly. Currently mounted to custom Tamiya highlift F350 with over 20 lights and a Bluetooth-enabled speed controller. Two servos control the lifting and lowering of the blower, and one controls chute direction; all connected to my 6ch radio. The blower motor is currently a brushed 550 and has a separate receiver/esc on a dial switch to control auger speed.
If you're interested, check out the Spyker workshops website, where you can find plans for purchasing this blower, and others!
spyker-worksho...
Негізгі бет Custom 3D printed RC snowblower, clearing 5+ inches of powder with ease! (part 2)
Пікірлер: 1 М.