looks like you don't have your filament tube connected to anything?
@vahvelpoiss
Күн бұрын
at that particular time - no
@crnalajna
20 сағат бұрын
Trident without triple Z?
@vahvelpoiss
20 сағат бұрын
oh you can actually see Z-pieces right there, not sure if you actually watched it. it was transitioning like every other modern person 🫣
@crnalajna
19 сағат бұрын
@@vahvelpoiss Yeah, I saw front rails mounted on the wrong side. ;) It it easy to be confused by following the Voron docs. Anyway just keep the printer alive, and fast... :)
@vahvelpoiss
18 сағат бұрын
@@crnalajna couldn't mount them to the right side because of thick industrial veneer sidepanels that use printed mounts for M5 bolts. had to make my own temporary design to figure stuff out and soon get some metal plates in the mix. it's a hobby project and I like figuring stuff out myself, keeps training the mind edit: look at newest upload
@oOWaschBaerOo
20 күн бұрын
what is that idler and a b motor mount setup ? im searching for smth like that where the idlers are minimal at the front and the tensioners in the back
@vahvelpoiss
20 күн бұрын
aTinyShellScript metal plates are used for idlers and motor mounts. I just got my hand on recycle bin special and used 4mm stainless steel lol
Пікірлер: 9