Always interested in Meshmixer stuff and this is a great technique Thanks
@daverussell27
7 ай бұрын
thankyou so much. after hours of trying different ways and now I can do it in a few minutes.
@Catuleba
7 ай бұрын
Awesome! Unfortunately this method doesn't work 100% of the time. I still don't know why, but sometimes there's just no way to make it work. But I'm glad I could help!
@manoelgomes8344
6 ай бұрын
ok, quick question, how are you doing to rotate the model and keep using the lasso? Whenever I start to draw with Lasso tool and release mouse, it act as if I'm finish drawing. If I hold shift I can keep drawing but the model rotation is simple terrible. Anyway, thanks for the vid
@Catuleba
6 ай бұрын
Unfortunately, I don't have an answer for that. It has happened to me. Sometimes I keep trying until It works, sometimes I just give up. Not the best answer, I know...
@pawelszyld524
9 ай бұрын
Thanks, that's was really helpful!
@kaoa10
7 ай бұрын
Man, thank you so much!
@Zombimajom
11 ай бұрын
Thank you! I can finally print a kairos model :D
@onurcalk4758
Жыл бұрын
Thanks for video 👍🏼👍🏼👍🏼
@AutismusPrime69
Ай бұрын
What percentage are you scaling the key up to? Resolution is too low for me to read
@Catuleba
Ай бұрын
The pin that will create the hole was 3.96 mm, and the key one I changed to 3.86 mm. I didn't use percentage. In my experience, leaving a 0.1 mm gap is enough space for any "discrepancy" caused during printing.
@AutismusPrime69
Ай бұрын
Awesome. Thanks for sharing this process. I followed it step by step last night and assumed a 1% scale down factor for the key in the model I'm working in. Yours is more of a 2.5%, so I'll do that in future
@stormelemental13
6 ай бұрын
how do you click and drag while starting on the model? I can only do that if I start off in the grey outside the model?
@Catuleba
6 ай бұрын
That's a good question. That happened to me a few times and I was doing the exact same thing as I always do. Unfortunately, meshmixer is a "moody" piece of software.
@andyw201
6 ай бұрын
great but would have been better with sound explination
@Catuleba
6 ай бұрын
I'm considering. Honestly speaking, I have a hard time putting my voice on record. Do you think a (good) AI voice would suffice?
@thomaswakefield6889
5 ай бұрын
@@Catuleba If you use AI to narrate a tutorial you will lose a lot of followers. I for one will be one of them. If you have a hard time recording your voice I suggest you take up a course in public speaking as it will help you in the long term. Especially if you want to continue to make videos like this.
Пікірлер: 20