I’ve been debating on purchasing a CNC just for the cabinets.😂
@xeontis
6 ай бұрын
If nothing else it's a good excuse.
@stevereese6488
Ай бұрын
Are you running a vacuum hold down table?
@MyDanglingUnit
5 ай бұрын
I’m wanting to use Mozaik with a Masso controller have you had any problems with the post processor? I see they have Masso listed on their website as compatible
@xeontis
5 ай бұрын
No issues, I did have to sort out the ATC commands on my own but that wasn't very hard to figure out. If you get to that point I'll gladly share what I have. I'm really impressed with the machining options Mozaik has.
@MyDanglingUnit
5 ай бұрын
Cool man I’m going to start my retrofit in about 6 months after my new shop is built just trying to collect all the information I can in the meantime
@MyDanglingUnit
5 ай бұрын
I just subscribed and I’ll make sure to give you a 👍 we need more content on the Masso and practical application like the above video
@wilsonmatos6734
5 ай бұрын
Those speeds look pretty darn slow, what's up with that.
Пікірлер: 10