This is the first test hole using the mag drill and annular cutter. the automatic lube dispenser was not used (empty) so it was manually oiled and the cutting was paused to break and clear chips, it is recommended to use constant pressure throughout the cuts for best surface finish. For comparison, cutting the other hole with a hole saw and 1/2" 20v portable drill was slower , not as precise , worse surface finish and required more effort to control the drill. Using the mad drill made this super easy, at one point I just pushed down with my thumb to cut.
- Күн бұрын
Cutting hole in forklift fork using Mag drill and annular cutter
- Рет қаралды 186
Пікірлер