Don't forget a respirator to keep from inhaling the highly poisonous dust too.~
@suspectdown5133
Жыл бұрын
I had .270 round dots. Needed .230. Used a "A" drill .234 dia. Super glued the dot to the shank end. Put the drilling part in the chuck of the hand drill making it run true. Ran the drill against the belt sander without touching the bit. Finished by hand (against sandpaper on table) and used the drill bit to apply the dot in the hole. You can use the drill end to ream or clean the hole. Make sure if you are picking the best side of the dot to be the top and mark the bit for the best direction of the dot. This worked well making sure to wait for the glue to set on the bit and in the hole before doing both.
@ConstrutorMusical
7 жыл бұрын
yeah... for some things the drill press is a must-have....but in this case you could use the hand drill with a piece of wood on the top of the MOP, as a guide, to avoid the drill tube to wiggle around... thanks man! I love your videos!
@zyxwvut4740
7 жыл бұрын
I was trying to figure how to clamp the piece down without cracking it; perhaps the wood guide on top of the abalone could be clamped, keeping *everything* from moving.
@abanikumarkakoti5899
2 жыл бұрын
Thanks
@aevoguitars2576
3 жыл бұрын
Just what i needed.
@realtruenorth
6 жыл бұрын
I gotta try this to make fretboard dots out of stone. You cant buy stone dots
@michaelshepherd1072
5 жыл бұрын
If you want a shorter route to a flat top use a tubing cutter which is a rotary action around the tubing circumference which also comes with a reamer to clean the ridge from the inside of the tubing. I love Dremel but jeez!
@Assimilator702
4 жыл бұрын
You could buy a drill press for a hand drill for less than $50. For small projects like this it’s worth it however threes a $100 Press from Skill that looks good for smaller projects. Once you graduate to everyday use it’s better to buy a larger unit.
@realtruenorth
6 жыл бұрын
Cant you just buy a 6 or 7mm diamond hole saw bit?
@NoahFielder
4 жыл бұрын
realtruenorth I did this and the reason it doesn’t work is the outside diameter is 6mm but the inside hole is smaller than 6mm
@charliemaddock3459
5 жыл бұрын
Like .....!!! A !!! BOSS 👌👏👏🤟I’m going to do this with abalone because I don’t trust the eBay abalone dots
@RaZzoRSnAkEpiT
5 жыл бұрын
Where do you found those shells?
@user-gl7xm3kf3y
7 ай бұрын
Too much time to make the tool. I'll just buy some dots.
Пікірлер: 15