What cutter did you use to cut this material? The cut was perfect!! Very good!!
@mason.berlin
2 жыл бұрын
I used a straight 8 mm twin flute.
@singaporeworks5694
8 ай бұрын
For the thin material do you use the vacuum? Thickness material we can hold the clamp how about the thin material sir?
@tonydevalt9932
Жыл бұрын
Hello, I'm very new at this. I have the Fox Alien Mauster Pro, and my question to you is, what is the thinnest or shallowest pocket depth I can mill out of my wood project? (Example) 0.001 in. Is this the thinnest depth that I can do, or is 0.00001 even thinner? Please let me know. And if someone is on this channel and would like to chime in as well, that would be very much appreciated 👍
@MrAndyhughes
10 ай бұрын
I’m extremely new to this , do you have another piece underneath so as not to damage the bed ?
@mason.berlin
10 ай бұрын
Yes
@ShuangShaneJiang
Жыл бұрын
Is there a formula of what thickness of material and the diameter of the bit that you can use to determine when you can cut out pieces without tabs?
@mason.berlin
Жыл бұрын
No, not that I'm aware of. Size helps. Larger pieces are easier, generally speaking.
@opensourceeducated2862
11 ай бұрын
We cut mostly plastics like HDPE and polycarbonate but also trespa and mdf. I will only do a depth of cut that is the size of the mill used. For 1/4" mill I use 6mm DOC, for 1/8" mill I use 3mm. And always do a finishing cut of 0.5mm
@sharmag5895
Жыл бұрын
How much material can be removed in a hour.
@AngelHernandez-yx3bm
10 ай бұрын
Polyurethane foam ?
@aflahabdurahman
Жыл бұрын
How can we safely cut shapes in very lightweight materials? like foam board and insu board.
@mason.berlin
Жыл бұрын
What is the thickness of the material?
@aflahabdurahman
Жыл бұрын
@@mason.berlin around 8 to 12 mm
@mason.berlin
Жыл бұрын
In that case I would recommend a 3 or 3.175 mm bit it can be twin flute or single. Ideally it should be down cutting or compression or straight flute.
@aflahabdurahman
Жыл бұрын
@@mason.berlin thanks for information
@samadabdul1242
Жыл бұрын
Where did you get the mdf sheet this thick?
@mason.berlin
Жыл бұрын
You have to buy the stuff wholesale. Also, it's not your typical MDF, it's much much lighter.
@watchclubent.3956
Жыл бұрын
What is the cost of a CNC like this one
@mason.berlin
Жыл бұрын
I'm not exactly sure. This particular machine doesn't actually belong to me. But I saw one for sale second hand, and it cost 7 or 8k
@xyzspec82
2 жыл бұрын
✅
@colinstables
Жыл бұрын
Thx
@mason.berlin
Жыл бұрын
Sure thing
@Kazuko-rq4qd
7 ай бұрын
Cutting shapes on a CNC router without tabs? That's how you test the true strength of your heart! 💔
Пікірлер: 26