If you noticed a drop in compression on one cylinder, and pouring a cap of oil through the spark plug holes didn't fix it, then it's likely you experienced a leaky valve or a burnt valve seat. What this test does is show you where it was leaking. Typically it takes a valve job to repair, but this can also occur on a freshly-machined head if any work was done improperly or out-of-center.
I'm using tap water for the test because both cylinder heads I'm testing will receive extensive machine work and cleaning before being re-used. If you were to do this test on a freshly-machined head, you'd want to use deionized water as it contains none of the salts (sodium, chlorine, etc...) that would leave deposits and corrode metal parts.
Негізгі бет Cylinder Head 102 - Hydro Test Valves
No video
Пікірлер: 82