I watched a number of these you tubes on how to wire up the breakout boards and the stepper motors. This one is good and everything works fine . Thanks for doing it.
@christophmuller7066
8 жыл бұрын
Do you connect direct - and pulse - to the break out board or do u trigger the 5v + channel? i See u have briged the 5 v + and enable Port right?
@КоляХутько
6 жыл бұрын
Good afternoon! Can you tell me ... to lead the true path ...? I need help in connecting endpoints, I need a connection diagram ... I can imagine how this should work, but the problem is that the board is powered by 5 V and the sensors are from 36 V.
@henryfitzthum7563
6 жыл бұрын
I'm alittle confused as I've seen the same drivers and breakout boards wired up differently, when I brought my kit it never came with a wiring diagram no paper work at all from Wantai also I think same as Longs and maybe many others, As I have the DQ542MA drivers, D25-1205 breakout board, I'm trying to trouble shoot to see why PC and breakout board are not communicating, but it's hard to know weather my wiring is correct everything is powered up with lights on so they are getting power and motor locks with torque load. I don't know weather the parallel port card I brought is not compatible as most PC don't have parallel ports only USB. I'm at a loss at the moment and wondering if someone has experienced this too
Пікірлер: 4