As part of my Lithium upgrade project for my 2015 Tab Max-S trailer, I am installing a DC to DC charge controller. This will allow my tow vehicle alternator to properly charge and maintain that battery. In order to run that charge controller I had to install a heavier gauge wire from my battery/alternator to the back of my truck where my existing 7 pin connector is located.
This video shows the results of that install of heavier conductors.
My truck is now ready to power the DC to DC converter/charger that I will install next week.
Music by Bensound.com
Негізгі бет Ғылым және технология DC to DC Charge Converter Installation Preparation - Heavy Gauge Wire Install (Part Two)
Пікірлер: 18