This is a series of four video tutorials in which I show how I make my homemade rear-disc DD pick for picking disc locks.
Below I show you a list of the materials necessary for its manufacture. Although in the video I say that I am going to put links to stores where they sell them, when publishing these videos, most of the sellers where I bought the materials have them out of print or the ad is not available, so I will not put such links. Most of the materials I bought from Aliexpress and ebay.
- Steel sheet 0.6 or 0.5 mm thick (any of those used to make homemade picks)
- Steel capillary tube 2mm OD diameter and 1.7mm ID
es.aliexpress....
- Round brass profile 10mm diameter.
- Thick wall aluminum tube 20mm OD, 10mm ID.
- Thick wall aluminum tube 19mm OD (can be any between 18 and 22mm) and 9mm ID.
- Aluminum tube 9mm OD and 5mm ID.
- Aluminum tube 6mm OD (can be replaced by internally threaded M4 bushings of 20mm in length)
- M4 Allen screws of 4mm length
- 1.6mm injectors and at least 15cm in length
es.aliexpress....
Негізгі бет DD002 - TUTORIAL DIY, DD REAR TENSION PICK. PROBE AND TENSIONER MANUFACTURING eng sub
Пікірлер: 30