This is the follow up on the project Electronic DC programable Load using Arduino which I have tested in breadboard in part 1. I was very much convinced by the result and I have decided to built this on a prototyping board. In this video I will be testing the updated design circuit and code. There are a few changes that I have made from my previous video.
You can download the code and schematic from my patreon page.
Here is the link : www.patreon.co...
If you like my work and want to support me, then you can donate any amount here: Support me via paypal: paypal.me/payu...
Gpay ID: smandal711@oksb
Негізгі бет DEC #07 - DIY Electronic Programable DC Load using Arduino | part 2 | final built of v0.1
No video
Пікірлер: 24