Real nice work, I refuse to have Stanliner tools, way too pricy for me.
@DentTamers
3 ай бұрын
Thanks. They are very pricy for sure but high quality.
@straightlines7432
3 ай бұрын
Nice work how long did it take on the left bedside? I may have to get that stanliner . On the deeper rear dent did you push on the tip or side of tool to move it?
@DentTamers
3 ай бұрын
I think around 2 hrs. I think I used the tip because of the angle otherwise I would use the back side.
@straightlines7432
3 ай бұрын
@@DentTamers oh the backside is soft ? How long is that tool? Do you use it down doors at lower part of door ?
@danielpowell4755
3 ай бұрын
@@straightlines7432I think it’s like 24 inches
@frogmanvc
2 ай бұрын
I am old skool. I am not familiar with Stanliner tools. I don't know what to think of them.
@DentTamers
2 ай бұрын
Try one or two of the most common ones
@straightlines7432
2 ай бұрын
Hi stanliner makes a number Of those round tip Tool . Which do you have the. 30 inch 3/8 raised tip ? They make a. 40 by 1/2 too
@DentTamers
2 ай бұрын
30 in 3/8 is the one I used
@yingvang3191
2 ай бұрын
Why do you hit the hammer 🔨 on different area where the dent aren’t at?
@DentTamers
2 ай бұрын
to push metal into low areas to strengthen the dented area
Пікірлер: 16