A friend had one of these go bad. He arrived home, grinder was running full time. Het switched it off, and after that the machine was complaining "no water". Turns out that probably the computer crashed and turned on the grinder and boiler. So thermal fuses of the boiler were blown, but also the plastic actuating the water tank microswitch was deformed - I presume from the heat of the grinder.
@chrisshepherd682
Жыл бұрын
How do you remove the infuser glide on right hand side when you open hatch, mine had snapped off.
@jonatasferreira6471
6 ай бұрын
Hey. Do you have a video showing the disassembly? Mine is randomly flashing the warning light which is supposed to mean the infuser is missing (which it isnt) so i assume theres an end switch sensor going bad somewhere
@coffeeexperts
6 ай бұрын
The warning red light keeps on or blinking means it’s error for descaling, try to find exactly what’s happened in your machine
@aps_bajwa_
2 жыл бұрын
Where is the ground container microswitch location ?
@DrMary32
Жыл бұрын
Hi! I have same machine but, it doesn’t respond to commands, if is plugged in, is playing alone: switching on and off, water comes out and in the end I cannot make any coffee as buttons are not responding to orders. What that might be? Thank you!
@jorjiulian3920
5 ай бұрын
same issue for me. did you sort the problem?
@DrMary32
5 ай бұрын
@@jorjiulian3920 no, i put the entire machine in the bin, as the spare parts were expensive and no worth the money. I gave up coffee after that…good luck repairing it…but delonghi is the worst coffee machine. internet is full of them broken….not sure if is worth repairing it
@yakumoklesk
6 ай бұрын
I bought a secondhand ECAM 22.110.B, and after cleaning the grinder, it seems that everything goes fine except that the grinding time is always too short. Do you know a solution for this? Thanks. Also, it is possible that you could check if the grinder adjustment mechanism (plastic gears), has attached in some place a tiny spring of about 1mm diameter and 1cm length and 2 small ball bearings? When I was cleaning it the spring just jumped and lost it, but I don't know where it belongs, just to buy another one.
@coffeeexperts
6 ай бұрын
Between the plastic gear ⚙️ mechanism 2small balls and 1 spring are missing . This is your question right? If you’re missing that small balls and spring you can’t fined anywhere. I advise you try contact nearest service centre. Maybe they have any old grinder parts they can fix it . If not found that things try to change whole the grinder set . From the manufacturer not provide that assembly parts. You have buy whole set
@davidlucena10
6 ай бұрын
@@coffeeexperts The fact is that it grinds coffee, but the grinding time is too short, about 3 seconds even when the front dial is at maximum. I can do a procedure to reset it but works only for the first time grinding for about 7 seconds, but then returns to 3 again.
@PRRugebregt
2 ай бұрын
@@davidlucena10 Hi David. I have the exact same problem with mine.. I can't find a solution anywhere. Could you maybe give me the procedure you use to reset it? Thanks. Right now I'm just grinding coffee with a separate grinder, which kind of defeats the whole purpose of this machine.
@jorgenavarrojr2183
Жыл бұрын
what grease are you using?
@coffeeexperts
Жыл бұрын
Use any Food safety grease or lubricant
@timelesskoontah
11 ай бұрын
Delonghi magnifica s ecam pc board replacement
@coffeeexperts
10 ай бұрын
You can replace it
@timelesskoontah
10 ай бұрын
@@coffeeexperts someone removed it and brought it for me but I'm trying to figure out the the individual wires are going..
@pityko92
20 күн бұрын
it can't make coffee for me, it just drips
@coffeeexperts
20 күн бұрын
Try to check coffee grains size, if it’s more finesse espresso will dispense too slow like you said drips or chances to blocking brewer or mechanical valve assembly
@pityko92
20 күн бұрын
@@coffeeexperts Thanks, it's fine at the moment, but now it doesn't stop pumping a lot of water when it's turned on when rinsing
@pityko92
20 күн бұрын
@@coffeeexpertsThanks! it's fine at the moment, but now it doesn't stop pumping a lot of water when it's turned on when rinsing
Пікірлер: 21