Morning from Australia, I've been trying to find some info on BL_heli 32, using very low KV motors (80KV) I managed to buy a second hand MicroDrone MD-4-1000!!! (for a very good price) I have flashed the latest 32.9. I am looking for some useful info on setting up the correct parameters... I have motor timing set to AUTO, high PWM set to (by RPM) (PWM low set to 48Hz) should I also decrease the ramp up too? From 50% down to 40%? I just don't want to get a de-sync on such a large copter, props are 2000 euro each, I cannot afford a mistake :-) Thanks for all your efforts.... Simon
@nerdCopter
4 жыл бұрын
+1👍 thank you, always great to get new POV, i'll go back to low & test 💪
@MCsCreations
4 жыл бұрын
Pretty interesting! Thanks a lot, Pawel!!! 😊 Stay safe there with your family! 🖖😊
@KCQuadTronX
Жыл бұрын
thanks for such a detailed and informative video ...see ya in the air !!!!!
@ThatCrazyGardener86
Жыл бұрын
Great explainer. Thank you Pawel
@FPVUniversity
Жыл бұрын
Glad you liked it!
@nikotttin
4 жыл бұрын
I have a small 1102 11500kv motor that only under load goes into a desync and roll of death. Demag is on high. Do you think this could be a case of too much compensation? --- I tried another motor and it does the same... hum... Anyone has an idea?
@machinedred
10 ай бұрын
My problem is my motor always starts up in wrong direction then corrects itself
@FPVUniversity
10 ай бұрын
This looks like a problem with one of the phases. It might be damaged. Check with different ESC
@machinedred
10 ай бұрын
@@FPVUniversity would demag comp have any effect ?
@FPVUniversity
10 ай бұрын
I don't think so
@djengines
4 жыл бұрын
Maybe top end esc's should have a hall sensor and a 36 -1 trigger wheel. This way the esc would not have to predict motor angle or rpm.
@DelaneyKassab
4 жыл бұрын
Does this same information apply to BLHeli S ESCs? I believe there is a demag option for them as well
Пікірлер: 16