Thanks for explaining how the windshield fits to the mask. I was wandering about that that it might be a problem down the line for that mask. The French version is a hard rubber has does no flex as much a as the Polish one like you have here in the video. The flexing could maybe pop the windshield out of that mask. I just see that as a design flaw. I would feel better if the shield was lapped into the mask at least a 1/4 inch to a 1.2 inch especially if it just a pressure fit and not heat pressed in or glued. Any way that's my concern about the Polish MP5 that you have here.
@pilotieasyfsxvirtualairlin1462
4 жыл бұрын
Hello, I ask you, certainly more experienced than myself, an evaluation for these types of masks mp5 maskpol and the like, I have seen the prices 20 - 30 euros and I do not care about the aesthetics as long as I can see what I have in front of me, the mask will have to to be used really a couple of times, obviously with all the appropriate filters of the NEW case, but I have reservations not knowing this type of mask or their condition, etc., etc., etc, would you know how to recommend a mask with an nbcr or similar theme? Are they sold without certifications but still real? Or are they just collectible replicas? I have often seen the most yellowed and opaque glass can it be cleaned or damaged irreparably? In your case where did you buy them? Do they also sell in Italy during this period with customs restrictions covid 19? Thanks
@techwg
4 жыл бұрын
If you clean the silicone screen be very careful... they are easy to push out and at that point it is totally wrecked. But also any used respirator can be useless. They need to be cleaned in warm water with a bit of dish soap, soaked there for a while, rinsed with clean fresh water and allowed to dry. Then you need to put a filter on it when it's fully dried out and put something strong smelling around all the areas of the face piece while you have it on, to see if you smell it. Pay close attention to wofting stinky crap around the exhale valve where air comes out when you exhale, because a bad exhale valve is VERY bad because if that is either damaged or not cleaned (and has gunk on it which stops the seal) then you are inhaling tainted potentially dangerous air from your surroundings that is not filtered. Air must only get to you through the filter. If you smell anything with an NBC type of ABEK2P3 filter, do not rely on the mask at all.
@techwg
6 жыл бұрын
From here: www.ebay.co.uk/itm/WHOLESALE-MC1-MP5-MP4B-MUA-M74-PRW-IP5-SR1-ML-SHMS-M17-GP5-PRW-NBC-MORE/263473118609?ssPageName=STRK%3AMEBIDX%3AIT&var=562502809695&_trksid=p2057872.m2749.l2649
@stephengoulding6124
4 жыл бұрын
GAS MASK NOOB HERE - Bought a Mp5 polish mask and I realised there’s holes in the voice diaphragm. Surely that should be shut or particles could get through ? Thanks for the help :)
@techwg
4 жыл бұрын
If the diaphragm has been punctured it would be useless. You must test it by attaching a good filter to it which can block gas such as an ABEK2P3 filter and then bring out strong smelling stuff or sit in a bathroom with TONS of cheapo airfreshener sprayed in there. If you smell anything after 2 minutes, you have big problems. All masks should be tested before relied on.
@Onthepissmylord
4 жыл бұрын
@@techwg the voice diaphragm is just a metal plate with holes in on mine, I dont understand how it would work.
@Satan-qp9lc
4 жыл бұрын
Best way to test if the mask is airtight is to put your hand over the intake valve (the part where the filter goes) and try to breath in, if air still comes through then you have a problem
@buzzbaar5218
3 жыл бұрын
Don’t worry it’s another copy of the mp5 gas mask
@amsetus
4 жыл бұрын
Great video. I have one of these masks. Any idea where I can buy the drinking tube? Bought one in Ebay but does not have the mask fitting/adapter.
@techwg
4 жыл бұрын
If they are not on eBay I do not know.
@alwaysarmed88
4 жыл бұрын
Does anyone know if this mask is CBRN rated?
@nickguh1234
3 жыл бұрын
Of course, it is
@onefive8859
4 жыл бұрын
For someone who is taking the current COVID situation seriously is this mask suitable for simply filtering the air around us. I won't be looking to buy this for any other reason than simply staying safe and taking precautions, thank you and stay safe
@techwg
4 жыл бұрын
Yes, if you get a P3 filter for it. You need a filter, else you'll be inhaling the same air as you would without it.
@onefive8859
4 жыл бұрын
@@techwg Would a PS10 be better than a P3? I'm using a site called preppershop and their filter you get with the polish mask is a PS10-NATO
@techwg
4 жыл бұрын
@@onefive8859 I have no idea what that filter is. P3 just refers to the particulate protection nothing else.
@kingbo2699
4 жыл бұрын
@@onefive8859 this type is P3 www.ebay.co.uk/itm/Scott-Pro-2000-PF10-P3-Filter-40mm-Thread-bio-protection-exp-02-2030/283841409075?hash=item4216443033:g:J2kAAOSwoLFejh0V
Пікірлер: 21