I use an air bag to support dents under brace area pretty cheap can get a set of three on Amazon for 15 bucks
@clist9406
8 жыл бұрын
Just wanted to add a suggestion. You can also heat the metal up then cool it off with a cold wet towel , It may take a few times since you can't get the metal as hot and keep the paint from blistering. however it will sink the metal stuffing up the panel and then push the dent out. I enjoy the videos , just helping share some tips
@kingbotzcustoms
10 жыл бұрын
Awesome stuff! So would I still be able to go to your site & purchase these videos if I didn't have a membership, or is it an all-or-nothing type deal?
@roadstar499
8 жыл бұрын
I would think you could add a sheet metal patch behind the oil can dent to prevent it from popping back in...I'm not a dent guy but construction adhesive and good size patch should do the trick...granted some areas it would be hard to do ...but hood has good access...this would be last resort
@k31v1n
7 жыл бұрын
A good trick is to stick a sheet of sound deadening on the inside of the dent. An old panel beating solution!
@246cuevas
8 жыл бұрын
did this a couple of days ago , peice of cake
@deanodebo
8 жыл бұрын
Not really a good example of an oil can dent there buddy, but yes your shrinkage advice is sound. Pecker marks and sanding a few rounds helps. Here's a pro tip: Weak open metal can be supported with a nice smear of bondo underneath as well.
@philipholman1713
4 жыл бұрын
Can someone link me a detailed video explaining pdr light usage and using fog. Thanks in advance
@razaqureshi5538
Жыл бұрын
If you have a id which could i also share some repairing videos to u which i also doing this work in Pakistan PDR😊❤️❤️
@philipholman1713
4 жыл бұрын
Seems like it's easy to learn bad form working just on your own with nobody looking over your shoulder to let you know what you are doing wrong.
@charlesmartelinhodeouromar8058
7 жыл бұрын
please post the traanslation into portugues , short short your videos !
Пікірлер: 15