Im not a dentist but I’m a patient. I just got 20 laminate veneers in Los Angeles. I told the dentist I want my teeth but white and he delivered. So much respect to this industry. No one even notices I have veneers but I have a beautiful natural white smile. 🙏🏽
@arek.b1256
7 ай бұрын
How much did you pay?
@itsaaronlolz
7 ай бұрын
@@arek.b1256 I got emax minimal prep porcelain veneers for 7500 from Hollywood star smile. It was the cheapest I found and he’s in Los Angeles so I don’t have to go to another country
@Atl404sFinest
6 ай бұрын
Thanks for noticing the hard work it takes to deliver dentistry to patients❤
@1zcott
7 ай бұрын
I will never forget how funny you were at the annual Cerec convention in Vegas, you brought down the entire house! Then Steve Martin and Martin Short came on stage after you and they bombed big-time. Fantastic technique!
@Bor.der.Collie
7 ай бұрын
This is the best and most detailed guide to grinding a tooth. I've already seen the tail with the ball and started preparing it like that. This really works excellently. Do you also do digital imaging with a scanner? If so, which one do you use? I have the one from Medit. Best regards
@sumairuddin9103
Ай бұрын
Software used ????
@syafiqramli658
7 ай бұрын
Once i tried it, instantly become a believer😂❤
@GlidewellDental
7 ай бұрын
Thank you for taking the time to watch this video. We appreciate it.
@charleskocun6754
7 ай бұрын
What are your thoughts on the vertical preparation technique verses this horizontal technique?
@subhash7408
7 ай бұрын
Sir tooth with internal resorption if reduced more no tooth left to sufficiently retained load in premolar molar areas
@kierra5498
7 ай бұрын
I’m a D2 student. Why are you using a round bur for the reduction instead of a “pear shaped “ or “flat end tapered bur”? Is it because you don’t need a chamfer or deep buccal margins? I’ll have to try the round bur for the margins.
@dr.fritzmora
7 ай бұрын
Round bur will produce a deeper chamfer-type margin and is more conservative than flat end taper.
@arek.b1256
7 ай бұрын
Is there any way to rebuild tooth (bottom 6) if the subgingival wall to which a large filling was attached has broken? My dentist said that its rather not possible, but It's hard for me to accept the loss of a tooth because it has many consequences, so I'm looking for a way.
@momo9594
7 ай бұрын
I would suggest you get a second and a third opinion. No serious dentist would advise you on a comment section on KZitem: too little clinical information. Wish you all the best. That said, there are ways like crown elongation. It all depends on the clinical picture: remaining tooth structure, parodontal status, etc... So I must stress: get other opinions.
@emonhossain8923
7 ай бұрын
Awesome
@valuedent6485
6 ай бұрын
Sir, if u teach your approach in a dental school, to an inexperienced dental clinician, CHANCES ARE, YOU'LL SEE A LOT UNDERCUTS ON AXIAL SURFACES!! YOUR TECHNIQUE TO AN EXPERIENCED CLINICIAN...... NO PROBLEM!!
@GlidewellDental
6 ай бұрын
Thanks for sharing
@charleskocun6754
7 ай бұрын
Pack this much cord on a thin biotype and you are guaranteed recession by the end of year 1
Пікірлер: 21