Sir I want to design amplification circuit for Current in range of 0 to 3.3 V. For that this circuit can i used?
@simulateelectronics5106
9 күн бұрын
Yes you can
@swetaroy17
3 жыл бұрын
good work but how did you find out input voltage 1mv and 2mv as your voltage showed 98mv
@simulateelectronics5106
3 жыл бұрын
Thanks for your response Since the gain of the amplifier is 100, so the output obtained will be equal to 100 times the difference of two input voltages. The formula used is Vout = Gain*(V2-V1) If you are asking why the output voltage is 98mV, not 100mv, then this is because the cursors are not adjusted properly to show the peak value. If you carefully adjust the cursors then you can observe 100 or 99mV.
@sahilinamdar6646
Ай бұрын
Sir I want to design amplification circuit for Current in range of 0 to 3.3 V. For that this circuit can i used?
@chongkangyi7252
8 ай бұрын
i cant find the probe, is there any alternative?
@simulateelectronics5106
7 ай бұрын
You can use multimeter or oscilloscope present on the right pane of the multisim window
Пікірлер: 14