I was trying to model a sheet metal 45° elbow and I spent 3 hours trying and trying with no solution. My boss demanden the 3D model for tomorrow at last. Thanks to this video, I will keep my job. Thank you, good sir!
@venkateshnayak8850
4 жыл бұрын
Very helpful, thank you🙏💕.
@CALearnings
4 жыл бұрын
You’re welcome 😊
@rameshjangir1099
3 жыл бұрын
Can you upload a video of flate pattern . of round hopper with flange
@CALearnings
3 жыл бұрын
Have a hopper drawing or image ?
@rameshjangir1099
3 жыл бұрын
@@CALearnings yes..I have.
@rameshjangir1099
3 жыл бұрын
How I can share image
@CALearnings
3 жыл бұрын
@@rameshjangir1099 fb CA learning page
@acewelding
6 жыл бұрын
This method does not work. If you make an assembly with all the parts without any interference, the elbow is no longer 90 degrees.
@dharmendrasuthar4342
Жыл бұрын
Yes exactly. How do you solve this issue...?
@acewelding
Жыл бұрын
@@dharmendrasuthar4342 extrude cut each individual part allowing for the interference, or sand down the interfering inner edges post forming
Пікірлер: 11