I just got my P1S set up and did a test print. However, in Bambu Studio when I cliick the MicroSD Card tab it says "Initializartion failed. (Not supported on the current printer version)!"
@rust_game_shop
Жыл бұрын
I hope they will add dashboard for farm and combine storage between printers
@jakubvyhnanek
Жыл бұрын
When there will be new FW for P1P? Thanks! 😁
@harrischristmastech
5 ай бұрын
You can access the files on the SD card, but what about the default files that come pre-installed on the Printer?
@PDWhite
Жыл бұрын
I love updates, good job
@UbberMapper
Жыл бұрын
Ummm...i could already browse timelapse from studio on my X1C...what i want to be able to do is on the P1S also.
@maticola6609
Жыл бұрын
Oh please bambu lab, i got every different project in files. And its complicated to see what file is what on sd card. Because your system is just showing the print files and not the files with the print files in it. Please make an update on that so we got every stl file in seperate files like we got in windows etc.
@assassinknives
Жыл бұрын
and a new version of slicer in the support section of the tree slim it does not work correctly
@hologos_
Жыл бұрын
Is this coming to P1 printers as well?
@BambuLab
Жыл бұрын
Sorry at this moment, this function only supports the X1 Series.
@oten22
Жыл бұрын
@@BambuLabCan we imagine this function in the future for the p1p?
@Nagggl
Жыл бұрын
@@oten22 They want people to buy the more expensive X1 so I bet we wont see it on P series.
@CurbCake
Жыл бұрын
that torse vase tho 👀
@selfworthy
Жыл бұрын
How do i print a file later on the p1p? For example i leave the house at 5am and want the printer to start my print at 8am ?
@dannikabiermans1200
Жыл бұрын
while it's not as easy as an update who does it all for you, what i do i load it before i go but stop the print before it does any printing, and then later on in the app i go in the history section and hit print again
@assassinknives
Жыл бұрын
The new firmware is bad, the layer does not reach the inner wall, there is a gap, this is very bad
@nickjeffrey8050
Жыл бұрын
Have no issues, running 3 x1c Thanks
@assassinknives
Жыл бұрын
@@nickjeffrey8050 it turned out that after the update you need to restart the printer and everything is fine, but the tree slim opros do not work correctly
@assassinknives
Жыл бұрын
@@nickjeffrey8050 it turned out that after the update you need to restart the printer and everything is fine, but the tree slim opros do not work correctly
Пікірлер: 19