Thank you for doing this video yesterday I went to buy a 1967 Datsun Roadster and I was towing at home with my 2010 1500 ram I lost my gauge on the oil pressure saying zero oil lamp warning light came on then a few minutes later another warning and then the engine lost power and some popping noise from underneath the car I’m hoping this is the problem
@ScottRods
Жыл бұрын
I’m concerned with this popping noise you talk about. When my timing chain snapped I got some popping or banging when I tried to start it as obviously the timing was completely out.
@glenmiller3783
3 жыл бұрын
I'm starting to think HEMI is just short for HEMIROID cuz they are a pain in the AS$
@dmwil7654
3 жыл бұрын
Oil didn't spill out the first time cause the truck was on that incline fromt he drive way. 2nd time you were further up driveway so truck was at a more level stance
@nickrussett259
10 ай бұрын
I have a 2010 ram also and my oil needle is stuck in the same exact position and my pressure is reading down to 1 or zero psi when at idle sometimes...what did you do to fix it? Did the sender unit work? Nevermind...I just finished the whole video haha
@NZMOPAR
3 жыл бұрын
It's windy here but 20c lol oh it's summer time to 😂
@DefaultName-vh3lo
3 жыл бұрын
Scott, If its like a Ford, it is just an idiot light switch connected to the "gauge". over a couple of pounds .75 sweep is what you get.
@leemackenzie549
3 жыл бұрын
I could kill for some snow, it was 32c today and its only the second day of summer, gonna be a hot one this year I think Great work on the truck 😁
@brianhaw9398
3 жыл бұрын
You did a great job of making that look difficult. Should have added a few grunts and groans and some colorful language just for fun. Enjoy all your videos
@ScottRods
3 жыл бұрын
Yeah, I know, lol. If I had that 27mm socket it would have been easy.
@TheStudderman
Жыл бұрын
I just got the p0522 code on my 2011 ram laramie 5.7 4x4 175k miles, my oil level is fine, my oil pressure is normal. After all my research and watching this vlog, I’m convinced its my sensor. I get nuts with my check engine light being on, it irritates the crap outta me.
@ScottRods
Жыл бұрын
I once got this code with having low quality oil. These engine can be very fussy about what you put in them.
@TheStudderman
Жыл бұрын
@@ScottRods I hope its not my oil, I just changed it about 6 weeks ago, I use 5W-20 by Mobile 1 full synthetic, so I can get 10 thousand miles between each change, roughly about 5-6 months. I literally got the code the next day after changing my battery. I had to jump start my truck two days in a row, so I went to my local AutoZone and they put the scan tool on my battery and said one of my cells was dead. So I Changed the battery, I drove it a few places that same day, later that day I came home and parked it. The next day I start it up, and the check engine light comes on, I hate that damn light, it makes my eye twitch lol. So I check my truck with my scanner, and the p0522 code comes up, I write it down, and clear the code, well as soon as I start it back up,….. BAMM the code comes up again, I try and clear it, and it pops up again. I did that 5-6 times, and the code keeps coming up immediately . Im not hearing any abnormal noises, Im not seeing anything wrong with my pressure on the dash gage, and my oil level is right where its supposed to be, and the truck runs fine like it usually does. I dont know…… Im fishing for answers, but after watching your video, Im pretty convinced its the sensor, not sending the right signal to my engine control module. Hopefully thats the problem. Thanks for responding, a lot of DYI youtube pages never respond. I appreciate it.
@ScottRods
Жыл бұрын
@@TheStudderman Sounds like you've done everything right. Generally when there's an electrical engine fault, the light won't come on till it has been triggered a number of times, but if that sensor is dead it might explain why it's more immediate. Just my theory, but hopefully that's all it is.
@TheStudderman
Жыл бұрын
@@ScottRods Well, The sensor was exactly what was wrong, I just got done installing the new one and I reset the code. I started the truck and it didn’t come back. Before I changed it, I experienced the same exact thing you did. When my truck was off my pressure was in the 90s. Now when the truck is off its zero. Thanks for your video and explanation. It definitely helped me! Happy Thanksgiving !!
@ScottRods
Жыл бұрын
@@TheStudderman Fantastic! Happy Thanksgiving my friend.
@robroten6446
3 жыл бұрын
First thing to check with the evap emission fault is the gas cap. Don't know if it being really low on gas would trip that fault if something was borderline.
@ScottRods
3 жыл бұрын
Before the timing chain "incident" I did have the gas cap warning light on. That started after I replaced the gas tank, so I'm fairly sure what needs fixed down there.
@bwsgarage
3 жыл бұрын
Thank you for getting gas, that gage level would cost me a sleepless night. 😆
@ScottRods
3 жыл бұрын
It only came on the night before when I got home. Good for another 80 miles, lol.
@davidsantos8206
3 жыл бұрын
Great job Dave, I was wondering if you have a Princess Auto or Harbor Freight Tools, near you. Because I looked up a 27mm deep socket at Princess Auto and it was only $4.43. And I know here in the states you a set of 12 deep IMPACT sockets for $19.99. I know because I am cheap and have bought 2 sets. Both in metric and standard. Also, did you remember to put tephlon on the new switch threads. I would hate to see you have a leak, because of something like that. Thank you for entertaining us
@ScottRods
3 жыл бұрын
Thanks David. Can't believe it was that cheap, darn it, lol. Yes, the new sender was pre-sealer'd.
@aplaskett89
Жыл бұрын
Can u still drive it on a faulty sensor
@ScottRods
Жыл бұрын
I have found out recently that if the ECU detects a fault, it might throw it into limp home mode, even if there is no actual mechanical fault. This is an old video now. I just replaced my ECU because it was detecting a misfire. New ECU does not detect that fault and the truck drives fine.
@davemartin4424
2 жыл бұрын
Put in a manual Guage. Get it from the top scotty. We bit easier lad. Lol
@bottomlineoutdoors6187
3 жыл бұрын
I have a 2008 Dodge Ram 1500 5.7L Hemi. Want to upgrade the cam and lifters, any suggestions on brands and where to order them?
@ScottRods
3 жыл бұрын
Sorry bud, I can barely afford stock, never looked into anything of quality, lol.
@randydoolitle6867
3 жыл бұрын
Life is what happens while we're making Plans.. Good work Dave
@deanbrunner261
3 жыл бұрын
Good job as always sucks to work in the cold and snow. Keep pickin away
@TurlosGarage
3 жыл бұрын
It may be cold but at least it wasn’t snowing.
@gambishchildino6542
7 ай бұрын
Very helpful, same exact thing happened to me with my 2011 ram 1500. Psi stuck at 88 with the engine off. The low gas aborting the remote start is the luck I’d have too 😂
@kentowens2179
3 жыл бұрын
Nice video, looks cold there. It's cold here in northwest North Carolina, USA too. Brrrrrr!
@ScottRods
3 жыл бұрын
The cold only hit me towards the end, then I got the shivers.
@AndysDogHouse
3 жыл бұрын
Hey Dave. Shit, You just reminded me of your live stream. I guess it is over now. When did you shoot this video? Is that lasts week snow, or is that a new storm? Thanks for sharing. I'm back. Did you say NEXT WEEK DEC. 7th right?👍👍🍁
@ScottRods
3 жыл бұрын
Yes, Dec 7th is next stream. The second half of this video was made today (Tuesday 1st December)
@AndysDogHouse
3 жыл бұрын
@@ScottRods So we have snow on the way then? Thanks
@ScottRods
3 жыл бұрын
@@AndysDogHouse I'm surprised it hasn't hit you. Started last night, snowed all day.
@AndysDogHouse
3 жыл бұрын
@@ScottRods My Grandson just came home from Pembroke (60km) north of here and they got 3 inches of snow. We still have ZERO. We got 10 INCHES LAST WEEK. It's been raining here for 3-4 days now.
@fieromike1
3 жыл бұрын
😂“Truck’s done”😂
@randyharter984
3 жыл бұрын
11 foot pounds of torque per dodge
@fosterpratt9437
3 жыл бұрын
THANK YOU SO MUCH!!!
@jean-michelb7290
3 жыл бұрын
how's the truck running at 291k km?
@ScottRods
3 жыл бұрын
Perfect thanks.
@TheCanadianBubba
3 жыл бұрын
Looking good Dave !
@danabrennan8191
2 жыл бұрын
so does the 2010 dodge rams with the 4.7 have a oil pressure switch and sending unit
@ernestosierra6980
2 жыл бұрын
On my ram my pressure is reading 24 I just replaced oil and better filter I need help
@ScottRods
2 жыл бұрын
It could just be a bad sensor.
@RedBoyPooh
3 жыл бұрын
Same code thrown on my Hemi Goat
@rosswilliams6011
3 жыл бұрын
Was that sensor all the way against the block?
@VinoRatRodbuilds
3 жыл бұрын
Andrew you're the man
@ScottRods
3 жыл бұрын
I'll let "Andrew" know, hehehe
@joeroyalgarage7995
3 жыл бұрын
Whew hooo!!!! Happy dance time!!!!!
@robshipman8691
3 жыл бұрын
It´s winter here as well Dave...and I´m working outside today on my Landrover...but it´s sunny and 19c here in Portugal...thats why I moved here from Edinburgh...lol
@ScottRods
3 жыл бұрын
Good choice Rob. My Mum is in Spain over Winter, climate is awesome there.
Пікірлер: 57