Worked great, I have a Shibaura 24 horse 3cylinder diesel, and I changed the fuel filter but it would not start after. I followed your instructions and bled the air out, still would not start, the Shibaura does not have the bleed screws like yours so I had to undo the injector lines and bled until the fuel appeared by turning the engine over. Reconnected the lines and it started after about 10 seconds of turning over. So no matter what the tractor your info is the answer. Thank you.
@helpinguonline
4 ай бұрын
Way to go!
@robbyddurham1624
3 ай бұрын
thanks, My father in laws just quit running on me while going up hill. The fuel filter is nearly empty. I'll check it out tomorrow. see if fuel is draining into filter from tank and if so, try bleeding it. It tries to start and run real weak for a moment. A few seconds. You're video gave me a starting point.
@helpinguonline
3 ай бұрын
Good to keep the fuel level up in the Tank. When my tractor hits a quarter tank if I get on to steep but he’ll it’ll pull air and then I have to fill the tank and bleed the lines. You can do it!
@robbyddurham1624
3 ай бұрын
@@helpinguonline That's probably my case here. I'm ordered a fuel filter, so I'm putting off bleeding it until I put it on. I watched a guy crimp the return line to bleed it. It didn't work for me. I also to replace the lines. They're original. 1980's. The return line was pretty rotten at the connection to the fuel tank. Thanks again for the video. It takes time to share your troubles. Most of us don't take the time and just move on after finding out troubles.
@lewishorton1426
2 жыл бұрын
Very helpful. Good quality production ! Thanks !
@gavincrispin1436
Жыл бұрын
new engine mounts too mate.
@FranciscoGonzalez-ro7ht
Жыл бұрын
thank you for this video
@helpinguonline
Жыл бұрын
My pleasure... thanks for the visit
@forgottenknowledge8917
Жыл бұрын
Put a plastic cup over the filter housing before removing it. You won't spill anything
@ej12ozcurlsmc
Жыл бұрын
My 955 will start fine, then die. Will start and run eventually after 5-10 starts, replaced the fuel filter but still does it. Any ideas?
@helpinguonline
Жыл бұрын
sounds like a fuel pump problem...either getting weak and loosing pressure or if older the solenoid on the fuel pump could be going bad.
@MikeOrazzi
11 ай бұрын
I have a 4600 that cranks and doesn't start even with a new fuel shut off solenoid.
@robbyddurham1624
3 ай бұрын
I was assuming it was gravity feed to the fuel filter. I might have fuel pump problem too. More food for thought. thanks again.
@allyleggett9975
2 жыл бұрын
Getting no fuel to filter
@MikeOrazzi
11 ай бұрын
So that's why I can't shut off my fuel supply, I didn't know you had to push it in and turn it. Maybe it won't be so messy next time, thanks.
Пікірлер: 17