6:37 OUCH! ;) Nice work on that unit... Seems like it is the Swiss Army knife of generators.
@JerusBarnett
5 жыл бұрын
LabWrangler it sure was windy that day, I video with my phone and thankfully it wasn’t hurt this time.
@jasonmushersee
5 жыл бұрын
nice score and looks like its got a throttle. my 3 wire 220v well pump would shut off shortly after coming on would get up to about 58 psi. i checked the voltage to pump at the casing and 1 side was 121v the other only 109v. traced it back to a loose wire at the square D breaker. as you see 109v too low to run loads
@exclusivesafar
3 жыл бұрын
Good job
@shellytrezelle2699
3 жыл бұрын
did it give trouble welding also ? mine does not weld too well. it welds but the arc breaks and starts again. its almost like the current goes up and down as the engine runs.
@jackmioff000
2 жыл бұрын
Adjust governor and idle, when it does that its bogging down and not getting enough air and too much fuel, it should rev up the engine when you strike an arc, could also be the carburetor which is what was wrong with mine
@Mikesorrento3344
5 жыл бұрын
Nice job. Question though. Are you happy with the overall quality of this welder generator? Thanks.
@JerusBarnett
5 жыл бұрын
John Rand The engine has been rock solid. The electrical side has been somewhat problematic. Give me a couple of more months to see how well it lasts putting it though it’s paces and I’ll know for sure. Biggest issue is there is no documentation, manual, or parts breakdown on this unit. Makes troubleshooting difficult at best.
@stevenmchenry8417
5 жыл бұрын
Great job
@marygracemasbad9369
5 жыл бұрын
hi ! do u have a part number of the diode? how about the woring diagram? i have a similar generator but cant figure out the wiring diagram
@rubabmohsin9694
3 жыл бұрын
Sir is this for sale?
@JayJay-rb6rt
5 жыл бұрын
do you have a service manual for that? and the schematic?
@JerusBarnett
4 жыл бұрын
No I do not. Sorry. It was pretty difficult just finding the correct voltage regulator. I could not find any direct documentation for this unit anywhere.
@JayJay-rb6rt
4 жыл бұрын
@@JerusBarnett Thanks for the reply, actually on your video, thats where i started ,my DIY approach in repairing the same generator. I live in Bulacan, Philippines , 2 hours north of manila. Problem was i dont have the correct avr. If you could please send me the picture of the AVRs including the wirings, to my email,: aeronuts2005@gmail.com then i could get it and share it with you including the documentations if any etc. Thanks and regards Jay
Пікірлер: 16