The X9C series of digital potentiometers feature a simple 3 wire control interface, provide 100 steps of wiper adjustment, and can optionally save the wiper position for automatic recall of the setting after power on.
Here's an Arduino Uno sketch showing how easy it is to control and use the X9C family of digital pots.
This is a follow up to two previous videos:
Digital Potentiometer Control Basics - X9C103
• Digital Potentiometer ...
Digital Potentiometer and Rotary Encoder Direct Control X9C103
• Digital Potentiometer ...
Sketch: github.com/Gad...
Original Library:
github.com/phi...
Workbench equipment I regularly use:
946C Solder Hot Plate 200mm x 200mm www.banggood.c...
ANENG AN8008 True RMS Multimeter www.banggood.c...
Minleaf NPS3010W Power Supply www.banggood.c...
FY6900 Dual Channel 60MHZ Signal Generator www.banggood.c...
Siglent SDS1104X-E 100Mhz Digital Oscilloscope 4 Channels Standard decoder
Amazon.com: amzn.to/36fH1ui
Amazon.ca: amzn.to/36fNWUc
(These are affiliate links. I may earn a commission if you shop through the links, it supports the channel and doesn't cost you extra)
Support me on Patreon: / gadgetreboot
#ElectronicsCreators
Негізгі бет Digital Potentiometer Control Using Arduino - X9C103
Пікірлер: 62