I was struggling to get the low beam installed until I saw your tip about putting the bulb in the hole fist, then push the socket in over it. That worked, as opposed to my first attempt at pushing in the bulb and socket in while connected together. Thanks!
@juggernautusa
10 ай бұрын
Glad it helped and thanks for your business!
@bamuz
Жыл бұрын
6:08 bbbbbrrrrooooooo I’ve had my promaster for a few years and never knew this CLUTCH like and rated for that!
@84miguelrivera
Жыл бұрын
What led lights reference I need what number for low and high thanks 👍
@Jason-vh6nr
10 ай бұрын
What happens if you plug in the wrong way positive and negative and negative to positive or is that even
@juggernautusa
10 ай бұрын
The headlight bulbs will line up with the housing so that it is always plugged in with the correct polarity. Of the fog lights don’t light up when power is sent to them, just unplug the connector and rotate it 180 degrees. No damage will be done if they are plugged in the wrong way!
@kwekalu11
Жыл бұрын
I want to upgrade my ProMaster 2023 too but I can’t find any led lights that fit 2023 let me know if you find one
@ranig2848
Жыл бұрын
Is it possible to replace the bulbs without removing the entire headlight housing?
@juggernautusa
Жыл бұрын
I’m sure you could. Honestly makes it much easier to just pull the whole assembly off. Pretty tight behind the drivers light.
@bamuz
Жыл бұрын
You can but no point in fighting yourself to get the bulb in
@TimotheosEnterprisesMedia
Жыл бұрын
Are these lED lights heated to help melt snow and ice off of the lenses?
@juggernautusa
Жыл бұрын
They don't put off as much heat as the stock halogens but definitely do put off enough heat to melt snow and ice.
@TimotheosEnterprisesMedia
Жыл бұрын
@@juggernautusa very good, thank you..... I need to switch to LED at some point
Пікірлер: 13