Never fail when you are trying to make hay. Crap breaks and then Rain. Have a great week.
@Mad_Farmer912
25 күн бұрын
One good thing this year is when we get good weather to make hay it's been absolutely perfect weather. A couple years ago it wouldn't stop raining and when it did most hay was borderline moisture.
@JamesSmith-ru2pw
26 күн бұрын
With the rain u need it for the corn and you don't need it cause u want to do hay so ur in between good and bad situations great job
@Mad_Farmer912
26 күн бұрын
@@JamesSmith-ru2pw at least it's not like a couple years ago where it wouldn't stop raining and couldn't get a lot of it dry enough.
@stevebean1822
26 күн бұрын
Vermier recommends 15 percent moisture for their balers.
@Mad_Farmer912
26 күн бұрын
@@stevebean1822 for dty hay definitely don't want much more than that.
@stevebean1822
26 күн бұрын
@@Mad_Farmer912I usually try to stay between 12 to 15 percent. Still bales good with net wrapping.
@kevb9578
26 күн бұрын
Dang discbines are built to fail nowadays. Them old Kuhn, krones and 1360 deeres just mowed till they didn’t. .I have my NH fail at least once a year now. Good luck
@Mad_Farmer912
25 күн бұрын
This one has been extremely reliable. Now it's getting some age it's not surprising issues happen a little more often. Just a involved process for a simple fix.
@obieacres4676
26 күн бұрын
Did you say how much the gearbox cost? Because we have one we are looking at a 1411 with bad gearboxs
@Mad_Farmer912
26 күн бұрын
If you mean the module gear boxes on the cutter bar, I've never had to replace one. I have replaced the top cap that the hub and turtle bolts too. I looked up on NH parts and it looks like there are left and right modules and they are $365 and $380. Also it looks like the top cap is separate for $263. Check with The Disc Mower Doctor in Ronks Pa. They specialize in disc mowers and other hay equipment. I don't know if something like these would be that significantly different in prices, but last year I got the front half CV PTO shaft from them. NH wanted $2700 and through them the exact same thing was $1500. I believe they also have salvage machines they part out.
@Mad_Farmer912
26 күн бұрын
A whole new cutter bar for a 1411 is $8990
@larryesmith5060
26 күн бұрын
I get phone calls all the time and I don't speak to them or call them back way I figure if I want to call them I will if I have a reason to but I don't
@Mad_Farmer912
26 күн бұрын
@@larryesmith5060 most of the unknown calls are scam or telemarketers anymore.
Пікірлер: 14