This is the exact video I needed! The manual isn’t clear on when or how the codes will be displayed, so I was very confused. Thank you for the clarification!
@PartsDr
7 ай бұрын
Great!!! We are happy that we could help!
@michellebalentine8311
Ай бұрын
So, is it safe to say I've cleared the error (replaced the heating element with help of your videos) if the diagnostic ends with "F-" and "E-" appear? As in letters with just a dash and no numbers.
@stevenbauer8033
6 ай бұрын
One missing and perhaps essential bit of information: The door needs to be closed when activating the service mode key sequence. I have a top control unit and the control panel is blocked by the counter top. I had to lower the leveling feet in order to have access to the control panel with the door closed. Yes, a front control model would have been a better choice in hindsight.
@PartsDr
6 ай бұрын
Thank you for sharing!
@johnniemo
6 ай бұрын
I discovered you can key in the sequence and THEN close the door. The code displays after that.
@janetmahler9820
7 ай бұрын
kitchenaid dishwasher model #kdfe304dwh0 the buttons light up but then go off and won't start. I turned off the breaker for about 3 minutes, then back on ... 😢 nope. When I push the buttons to enter diagnostic mode, the lights don't come on. I'm pretty handy but at a loss here. Any help would be appreciated!
@PartsDr
7 ай бұрын
Sometimes if the buttons on the touchpad fail or short it can cause it to act like you are describing.
@nicT9
7 ай бұрын
This is the video that showed the correct sequence for diag mode on my Maytag dishwasher. All other guides and videos showed wrong techniques for Maytag MDB4949SHZ0
@PartsDr
7 ай бұрын
Great! We are glad this worked for your Maytag dishwasher.
@tevman69
5 ай бұрын
I have the same model, thanks for your comment!
@Garedot
4 ай бұрын
Can you share the pdf of codes ?
@PartsDr
4 ай бұрын
They vary depending on the model number of the dishwasher. This is why we instruct you to locate the tech sheet at the beginning of this video.
@mnight207
6 ай бұрын
My lights stay on
@stevenbauer8033
6 ай бұрын
Are you pressing the key sequence wit the door open? I had the same experience until I learned that the door needs to be closed.
@salukirich9824
10 ай бұрын
Didn't help at all. My whirlpool doesn't have 3 buttons to push.
@PartsDr
10 ай бұрын
Try locating the tech sheet for your model and using the instructions listed there. kzitem.info/news/bejne/0KVomHlrmIOaeII
@vandal968
8 ай бұрын
That's what I thought too, but it turns-out it won't go into diagnostic mode if you haven't totally exited the last cycle.
Пікірлер: 18