www.solidremote.com - Solidremote SR-D1 is 100% compatible with DITEC GOL4, BIXLG4, BIXLP2 and BIXLS2 garage door remotes, suitable for most DITEC roll up remotes, sliding door remotes, slide gate remotes and swing gate remotes as well as all other current DITEC radio entrance automations.
There are several ways to program your new Ditec GOL4 remotes, as follows.
If you would like to program Ditec GOL4 to typical DITEC BIXLR12-22 receiver, refer to follows.
1. Press the PRG button on the radio receiver or on the control panel, the SIG LED lights up.
2. Make a transmission by pressing one of the desired CH buttons of the transmitter (within the range of the radio receiver). The transmitter is now stored. During this phase, the SIG LED flashes. When the SIG LED is again lit up, it is possible to validate another transmitter. Validate all the new transmitters by making a transmission as indicated.
Note: with JR4=ON all the channels are stored, with JR4=OFF only the channel key that is pressed is stored.
3. You automatically exit the procedure 10 seconds after the last transmission, or you can press the PRG button again (the SIG LED goes off).
4. Press the transmitter button to test operation.
If you don't have access to your receiver or control panel, you can do it remotely, as follows. *** you do need at least one original DITEC GOL4 transmitter that is already coded into the opener and turn JR5 to ON position.
1. Take any pre-coded original DITEC GOL4 transmitter. Press the PRG button for 5 seconds, until the LED comes on within the range of the radio receiver.
2. Then using a small needle press through the Coding Hole and hold firmly for two seconds.
3. Within 10 seconds, take the additional transmitter you wish to code.
4. Press the transmitter button you would like to use to control the door for two seconds.
Note: Be careful not to accidentally store unwanted transmitters during remote learning procedure.
Негізгі бет DITEC Gol4 compatible remote control
No video
Пікірлер: 3