I don't understand what all the clicking was for to cut out the aileron. In Fusion, once you had your side aileron sketch it would have been 5 clicks and done, not even 30 sec.
@dynamixsystems
10 ай бұрын
It was my fault, now I'm more comfortable with it, and it doesn't take that much.
@ferhataksin4081
Ай бұрын
Hello, how did you separate the winglets from the wing?
@dynamixsystems
Ай бұрын
Yes, because I wanted to put navigation lights inside of it.
@ferhataksin4081
Ай бұрын
@@dynamixsystems Winglet, can you tell me how she left the wing?
@dynamixsystems
Ай бұрын
@@ferhataksin4081 The same Split command. once you split a body into divided sections, you can save all of them as new files externally.
@ferhataksin4081
Ай бұрын
@@dynamixsystems Thank You
@dynamixsystems
Ай бұрын
@@ferhataksin4081 Welcome, my friend.
@ferhataksin4081
Ай бұрын
Hello my friend, What is the length of the wing in mm?
@dynamixsystems
Ай бұрын
Good day my friend! The wing span is 1060mm and 30mm of the each wingtip is the winglet. that's because I wanted to integrate both wings an fuselage with 1m carbon fiber tube.
@ferhataksin4081
Ай бұрын
@@dynamixsystems Is the length of the wing in this video 500 mm?
Пікірлер: 11