About The Project:-
This is an Arduino based RC Transmitter built for controlling cars and tanks.
It has 2 Analog stick one of which controls the movement of the robot and the other is used to move the camera around. Three different buttons to control some instruments on the robot , two of which are tied to a safety switch.
The sate and values of the buttons and analog sticks are sensed by an Arduino NANO and sent via a NRF24L01 module.
I am using the amplified version of it so that it has increased range and make the controller look good with is antenna.
The FPV system is kept separate and can remained turned off if not required to save battery life.
Made with a regular FPV receiver and a 12v 7 inch screen in which the output signal from the FPV receiver is straight fed into the screen also by removing the casings, makes the system a lot smaller.
Affiliate Links:
Display: dir.indiamart....
Switches / Buttons:
You can find the code here -
github.com/INO...
For any business queries contact us at inovatrixhelp@gmail.com
Негізгі бет DIY Arduino 2.4 GHz RC Transmitter and Receiver With FPV Screen | With NRF24L01 7 Channel
Пікірлер: 25