add in a double pole on off switch and you can make the cut leads switchable for returning to factory radio condition when bluetooth isn't being used.
@tyronenelson9124
2 ай бұрын
You also need to remember to incorporate noise suppression circuitry, as these BT modules put a lot of electrical noise onto the ground lines of the actual car stereo amplifier.
@TechUpBuilds
2 ай бұрын
I haven't had any issues yet an I've done a few of these.
@simonilett998
2 ай бұрын
How do I do it if I still want to use the radio?
@ashraaqwahab2817
2 ай бұрын
Alternatively, would it be possible to wire it to the cassette player input instead? Since some people might still want FM radio, but not need the cassette deck anymore?
@stevencarlson5422
2 ай бұрын
Also could wire in some diodes and maybe a switch for turning it on or off
@TechUpBuilds
2 ай бұрын
I had issues with trying to get this to work, as it was my first idea. There is a little preamp IC on the tape deck but it had no luck getting a clean signal.
@wyokaiju992
2 ай бұрын
@@TechUpBuilds Ive managed to do it on a ford Crown Vic So it varies by radio for sure
@stevencarlson5422
Ай бұрын
@@TechUpBuilds there is a thing called a Bluetooth cassette adapter that works just as good and no modifications needed
@TechUpBuilds
Ай бұрын
@@stevencarlson5422 I don't like how you have to recharge them, and not all radio's have a cassette player.
Пікірлер: 11