WARNING: YOU SHOULD USE SOME STRAPS TO PREVENT THE PULLER AND ROTOR FROM VIOLENTLY FLYING OFF OF YOUR VEHICLE AND INJURING YOU. THERE IS A LOT OF STORED ENERGY AS YOU BUILD UP PRESSURE.
I would recommend you get an OTC 6980 if you are able to, otherwise, it is possible to make a reasonable replacement from stuff laying around your shop. In this video you will see how I made it and removed two brake drums. I also use my MityVac vacuum bleeder in between so that I do not overflow the master cylinder.
Affiliate Links:
-OTC 7-ton Puller: 6980, amzn.to/3k9GcdK
-Astra Pneumatic 8.5-ton Puller: 78830, amzn.to/2Xi6DFP
-Ratcheting 2-ton Puller: Various, amzn.to/3lpI4yz
-Impact Drill Bits: Milwaukee Titanium, amzn.to/2YS8JMN
-Fluid Film: Various, amzn.to/3EkAr5h
-Vacuum bleeder: Mighty Vac 6830, amzn.to/3CbyNRp
As an Amazon Associate I earn from qualifying purchases.
Негізгі бет DIY Brake Drum and Rotor Puller
Пікірлер: 3