Schone machine Fred. Toch heel wat robuuster dan mijn lowrider 3. Zeer benieuwd naar vervolg. 🙂
@amirmetin
5 ай бұрын
hi nice work! can you share your plans i want to build a similar machine please
@RJCLN
6 ай бұрын
This is amazing!
@bukunmioyedapo45
6 ай бұрын
Why two spindles?. Also why drill bits, won’t an up cut bit do the same action a drill would?.
@fredraket
6 ай бұрын
I still have to learn all that, but I don't mind having an extra mini spindle. I don't sacrifice that much space and I can also put a V router in there. is going to come in handy somehow
@bukunmioyedapo45
6 ай бұрын
@@fredraket essentially a two head, that can replace an ATC to a decent degree, not bad at all, just use offsets when you program your gcodes.
@kazolar
6 ай бұрын
what's the point of the washers between the rail and extrusion?
@fredraket
6 ай бұрын
i used blind rivet nuts these were sticking out a little and to enlarge the support surface a little I put a washer between the hgr rail
@overtinker.projects
6 ай бұрын
Impressive! Looks like a lot of work
@fredraket
6 ай бұрын
as @henkrijckaert would say dat was meer werk als verwacht 😅☕
Пікірлер: 10