No lathe required! Fabricating a jackshaft (3rd pulley), to reduce the speed on my Delta DP 220 drill press, without using a lathe. I've seen some great DIY jackshafts on the Internet, but they all require the use of a lathe, which I don't have. Slower speeds will allow me to drill larger holes in thicker material without ruining drill bits. I used a Westward center pulley assembly ( TT10409513A1G ) but, this same type of pulley assembly is used in almost every 3-pulley drill press. So, if you can find one on any of the replacement parts websites, it would work the same. See the links below for the parts and tools I used:
Pulley Assembly:
amzn.to/3wH0i2y (affiliate*)
Link Belt:
amzn.to/3dICylP (affiliate*)
Shaft Collars:
amzn.to/3by78gi (affiliate*)
3" Hole Saw:
amzn.to/2R2aY9x (affiliate*)
2 5/8" Hole Saw:
amzn.to/3ayqOjP (affiliate*)
1" Hole Saw:
amzn.to/33Z6TZ3 (affiliate*)
Hole Saw Arbor & Bit:
amzn.to/2xAbSDo (affiliate*)
*Purchasing from these Amazon affiliate links earns my channel a small commission. Think of it as a tip that doesn't cost you anything. Thanks for the support!
Негізгі бет DIY Drill Press Jackshaft Speed Reducer
Пікірлер: 64