Great Idea, cheap dubbing brush "machine". Congrats, thanks for sharing. Cheers.
@theodoreeisele
4 ай бұрын
Very clever. Thanks for sharing this.
@chelenthal
3 жыл бұрын
Thank you for this! You saved me 60 bucks on a wooden jig, and who knows how much on store bought brushes.
@shanedaigle7751
2 жыл бұрын
this is actually very helpful, saves a lot of money and its just as effective
@dfisher1000
3 жыл бұрын
Cheers buddy . That was simple and very cool 🎣🎣🎣👌👌👌
@RespekfulFungus
3 жыл бұрын
I know it’s been said, but this just saved me a chunk of money. Ty sir!
@reelteacher
Жыл бұрын
Awesome! Thank you for sharing!
@judgetoogood1033
Жыл бұрын
IKEA makes a milk coffee frothier for only $2.99. Works great, small and light, for spinning your brush. Recommended by Gary Borger…
@David-uj2ms
4 жыл бұрын
You can use a C clamp to hold the cutting board in place. I just hammered a nail in my fly tying table and achieved the same results.
@carefulkev9246
4 жыл бұрын
If you clip the ends off the paper clip handle, you could chuck both legs into the drill simultaneously and get a much tighter revolution.
@2xtremefishing
7 жыл бұрын
you could use a screw eye in the drill...
@toddfullerton3930
6 жыл бұрын
Excellent!
@runejl1
7 жыл бұрын
Simple! Thanks!
@NickM95
Жыл бұрын
Anyone done this by hand without the drill? I figure it should work fine, will just take longer.
@mikeking453
4 жыл бұрын
That's crazy
@mikesueirro4968
6 жыл бұрын
How is a dubbing brush an improvement over a simple dubbing loop?
@kjs311
6 жыл бұрын
Mike Sueirro you are able to make them before hand.
@phoult37
6 жыл бұрын
3 advantages: 1) The wire around the body makes the fly way more durable than a thread-based dubbing loop, which is essential for Pike/Muskie flies. 2) You can mix multiple materials of varying length more effectively 3) You get better portion control and can build tapers into the loop more easily
@scottmehlhaff8124
6 жыл бұрын
thanks Pat, I'll try it.
@phoult37
6 жыл бұрын
I made a brush combining schlappen and ice dub. Gunner Brammer has a video on it. It took me a few tries, but they turned out pretty well after some practice.
@mg-by7uu
5 жыл бұрын
I tie the majority of my flies using composite loops. I'm going to attempt to turn my loops into brushes because I think it will help with speed and more importantly consistency. Consistency, as any good fly tier knows, is one of if not the most important aspect of fly tying.
Пікірлер: 23