This video is a video of the SK11 STS-255ET table saw, continuing from the previous one.
In the previous review video, it was said that it is a sufficient product for amateur DIY for the price, so this time I will make a cross cut thread (jig for crossing) to make when I buy a table saw. to go.
The materials used were softwood plywood (11 x 910 x 910 mm), veneer (4 x 600 x 300 mm), 2 x 4 lumber (1820 mm), and red pine rafters (30 x 40 x 990 mm).
There is no need to use these materials, and even the size of the base plywood may be sufficient for the table size of the table saw.
The work is very easy and one day is enough to make it. If you are forced to pay attention, set a ruler on the front side at right angles to the saw blade, and set the saw blade at right angles as you did last time with the base and saw blade.
By making this simple jig, you can use the table saw safely and easily.
However, although this table saw was purchased for the purpose of vertical cutting, unfortunately this jig cannot be used for vertical cutting.
I'm thinking of making a jig for vertical cutting from the next time onward, but first I tried to make a jig for horizontal cutting by shoulder break-in.
Let's start the work, please watch until the end if you like.
――――――――――――――――――――――――――――――――――――
--- SK11 STS-255ET Table Saw Amazon Purchase Site
――――――――――――――――――――――――――――――――――――
www.amazon.co.jp/SK11-%E3%82%...% A5% E7% 94% A8% E3% 83% 86% E3% 83% BC% E3% 83% 96% E3% 83% AB% E3% 82% BD% E3% 83% BC-% E6% 9C% 80 % E5% A4% A7% E5% B9% 851000% C3% 97% E5% A5% A5% E8% A1% 8C570mm-STS-255ET / dp / B07GSL4BTG / ref = sr_1_9? __mk_ja_JP =% E3% 82% AB% E3% 82% BF% E3% 82% AB% E3% 83% 8A & dchild = 1 & keywords =% E3% 83% 86% E3% 83% BC% E3% 83% 96% E3% 83% AB% E3% 82% BD % E3% 83% BC & qid = 1632189041 & sr = 8-9
――――――――――――――――――――――――――――――――――――
--- The tool used this time
――――――――――――――――――――――――――――――――――――
・ Makita Rechargeable Impact Driver TD110DZ 10.8V
・ KIMO Electric Impact Driver 12V Rechargeable
・ Shinwa Freedom Square 250MM
・ HITACHI Slide Circular Saw C8FB
#DIY
#garage
#Table saw
#Crosscut thread
Негізгі бет Тәжірибелік нұсқаулар және стиль [DIY] Easy cross-cut thread jig manufactured for SK11 table saw
Пікірлер: 2