Love the design, when I finished univeristy I should of moved to bareclona rather then living in Ireland so your making me jealous
@riandavidsonstudio
5 ай бұрын
Thanks very much! I’m sure you still can! I didn’t move to barcelona until I was almost 30. Irelands also nice though! Lots of woodworking around :)
@darkknightmw
5 ай бұрын
Nicely done! Seems like a lot of work but the results are great
@riandavidsonstudio
5 ай бұрын
Thanks very much! It’s definitely a lot of work but I was happy to take on the challenge. I think it has the potential to have some really nice applications outside of countertops as well. Thanks for commenting!
@6Ginge
5 ай бұрын
Nice work. I think I would have tried to hide the joins in the 30mm lengths where the sink and hob cutouts were.
@riandavidsonstudio
5 ай бұрын
Would have been nice but the spacing unfortunately doesn’t work with those lengths. I would have had to cut all the full lengths shorter and would have wasted a lot of material.
@stuartibbotson7179
5 ай бұрын
thats devine
@riandavidsonstudio
5 ай бұрын
Thank you very much! Appreciate it :)
@Arturas1244
3 ай бұрын
and stop first thing he does is wrong! ripping plywood!, he doesnt know why he needs to rip, he just made same wrong corner, so why he even did this?, place rip saw the edge track is corect line the plywood corner is not, you buy extra cheap 90 degreee corner for you track. which simply locks into track its cheap plastic and you use any stright line and it will make track in 90 degree corect corner. he probably never went into school. he thinks if he will cut side corner by rolling same wrong line magically will apear 90 degreee corner dear god he have low grade in scool. plywood from factory has wrong angles, so you use tracvk saw to have corect 90 degreee angles and to make smaller pieces which are little bigger than you need to, than you use saw desk to cut precise size, but from start it will be corect 90 degree pieces. you can even use only tracksaw to cut al pieces needed
Пікірлер: 10