Thanks for watching my videos. If you like it, please LIKE, SUBSCRIBE and SHARE. You can also write a POSITIVE or NEGATIVE comment below.
@ltan888
10 ай бұрын
The main problem with this type of cheap desoldering iron is the rubber seal between the heater pipe and the plastic holder (inside the joint where the 3 screws are located) will deteriorate and melt after about 45 minutes of usage. Thereafter, the suction power will be very much diminished due to the air leak, thus rendering it useless.
@user001sg9
10 ай бұрын
Very informative video, thanks. Which vacuum pump did you use. Rough specification would be helpful.
@dismayer666
3 ай бұрын
not very informative if you ask for that :P
@user001sg9
3 ай бұрын
@@dismayer666 This is no contradiction. The video is very informative in that he one could learn as to how he realised idea in practice. Still, this can be done using many types of vacuum pumps with respect to its performance (e.g. amount of air suction per minute). I requested that information to avoid using an over or under dimensioned vacuum pump for my implementation. Hope this clarifies. ;-))
@lpgoodsale3427
8 ай бұрын
May I know what is the Pump you are using? and where to buy it? thanks in advance
@bineshchauhan8713
2 ай бұрын
I want it completely how prize
@alfs3332
Жыл бұрын
Nice video! Please partslist..? ;-)
@DJMotavirust
4 ай бұрын
No filter, your pum will stuck very quick. Put at least, a piece of cotton inside the tube and protect it with a piece of aluminium before it.
@a.hashik4786
2 ай бұрын
😂😂😂 u cut the part of video when when ur desoldering
Пікірлер: 10