you can rebuild the maple ridge with metal reinforced epoxy or bondo (jb weld ect)... I have made dies for hammering copper into out of mdf and is it wears using bondo holds up pretty well with the steel and maple made mortising a stiffening rib and then shaping the other product over. You vid's are simple and get the point across thank you
@itsnot_stupid_ifitworks
2 жыл бұрын
Yes. If i was to do this again i would stamp a small piece first then fasten /laminate it to the wood . Then stamp the metal on top of the steel laminated to the wood.
@DIYCraftBazaar
5 жыл бұрын
Great 👍👌
@jasonwoody
5 жыл бұрын
Has part 3 been posted? Couldn't find it...
@itsnot_stupid_ifitworks
5 жыл бұрын
Part three is not released yet. The brewery/restaurant is open now an I need to get some final footage.
@hiteshgangwani9030
5 жыл бұрын
hello i want to make same hydraulic stamping machine please guide me i am an mechanical engineer
@itsnot_stupid_ifitworks
5 жыл бұрын
I wish I had time to help but i barely have enough time to fulfill my business obligations.
Пікірлер: 7