Entertaining, but waaaaaaaaay overkill. Try this: Thread the blank on a bolt, chuck it up in a drill, hold it horizontally over a spinning router that has a round bit. (It'll even work if you do it over a sawblade. Won't be as repeatable, of course)
@craftandconstruction3359
2 жыл бұрын
Overkill is the way we design things in germany 🤣 Thanks for your tip 👌🏻
@timffoster
2 жыл бұрын
@@craftandconstruction3359 Ha! Fair enough. I have a German uncle who would agree :)
@attilabori4734
2 жыл бұрын
@@timffoster Vorsprung durch Overkill oder was...:)
@kamleo1685
2 жыл бұрын
Wouldn't it have been easier to make templates and route out the parts?
@craftandconstruction3359
2 жыл бұрын
Sounds good... i do it on that way because i want to use the middle axis of the pulley as the turning axis for milling ✌🏻
Пікірлер: 6