One of the few installs that shows how to cut small inspection hole first and then to proceed to cut shallow to avoid hidden wires and pipes. Creative idea to notch a chunk out of stud on the left. IMO you should also caulk around the framing so no water gets behind the framing and settles at all. This is true moisture prevention.
@jesikabaldwin5188
3 жыл бұрын
Loved this video!!! Just bought our first home and you made me feel so much better! Haha I'll be using your video when installing our doggie door, thanks again!
@varungorthy3582
3 жыл бұрын
two reasons I love this video.... German Shepard, and BLM message right off the bat! oh also very easy instructions! Thank you for the video.
@Maugwa
2 жыл бұрын
fug blm.........extorted all that money and haven't spent a GD penny on ANY BL! They kept those millions for themselves.
@danielreymundo79
2 жыл бұрын
I'm gonna be installing one of these tomorrow .great help with basically any problem that you can run across was covered.thanks again.👍
@shannonphx407
2 жыл бұрын
Very helpful. Thanks!
@dontdomeboo81
2 жыл бұрын
you could have put one in your Slider door like i did.. super easy maybe 10min setup
@samuelugh5729
Жыл бұрын
i did that and now there’s a gap between the door. Where the door used to close and air comes in.😏 now i wish i did this.
@AntonioTorres-jx1rm
Жыл бұрын
Can you show a picture please? Because i have not seen one in a slide glass door
@dontdomeboo81
Жыл бұрын
@@samuelugh5729the gap is probably due to the foundation being off mine is too but i put spray foam where the gap was now everything is good
Пікірлер: 10